Healtech FI Cleaner Tool for Kawasaki

Switch off your FI error code dashboard light
Fast and cost effective FI error code cancelling tool for Euro4 emission class motorcycles - just plug it in and get the job done effortlessly!

The problem...
Your motorcycle's engine management system monitors the various sensors on your bike and whenever a problems’s detected the FI light comes on and stays on - annoyingly, even if the fault condition no longer exists (e.g. if a loose connector was reconnected, or if your bike was started during maintenance with a module disconnected, such as the exhaust flap servo motor).

This can ordinarily take a lot of time to get the error cleared without the use of - a generally very costly - OBD (On board Diagnostics) Tool.

The solution...
Just plug the Healtech FI Cleaner Tool into your bike's diagnostic connector, turn the ignition on and see the result on its colour status LEDs. The code or light will extinguish within a few seconds if the problem is resolved, but for your safety, the FI Cleaner Tool will not clear the FI light if the error is still present, plus it doesn't clear the error history (stored errors) from the ECU, so it’s still possible to troubleshoot recurring problems later if desired …all so much quicker and simpler than using an OBD tool.

• Quick and simple to use - just plug-in, turn on the ignition and it's done in a few seconds
• Cost effective - much quicker and more convenient than using an OBD tool
• Save on servicing time and bills - faster turnaround and lower costs for workshops
• Advanced Tech - compatible with multiple bike models
• Built to last - rugged oil and water resistant design
• Light and small at just 30x20x13mm and only 20g